Updated November 2026

A Bodum Schiuma milk frother turns cold or warm milk into light, velvety foam in under a minute, which is enough to top a latte, cappuccino or flat white at home. The results depend on three things: the milk you pick, how cold it starts, and how you pump the plunger. Follow the steps below and you should get consistent foam every time.

What the Schiuma Does and Why It Works

The Schiuma is a handheld, plunger-style frother. You pump a fine mesh disc up and down inside a small jug or glass, which pulls air into the milk and breaks it into small bubbles. Because it does not heat the milk, the foam is mostly air and texture, so it suits cold drinks as well as hot ones. Bodum’s own documentation describes the device for both cold and warm milk, and that is the setup most owners use.

Shopping for one? See our guide: 7 Best Milk Frothers and Steamers for Home Use (2026).

Choose the Right Milk and Temperature

Whole milk produces the thickest, most stable foam because its fat and protein help hold the bubbles. Reduced-fat milk works but gives looser foam that collapses faster. Oat, almond and soy milks can froth too, though they often produce thinner results; barista-labeled versions are formulated to foam better. For the best foam, start with milk straight from the refrigerator, around 38 to 40°F. If you want warm foam, froth first and then heat the milk in a saucepan or microwave, since heating before frothing tends to cause the foam to deflate quickly.

How to Froth Milk with the Schiuma, Step by Step

  1. Pour cold milk into the jug until it reaches about one-third full. Milk roughly doubles in volume, so leave room.
  2. Hold the jug steady on the counter. Place the frother’s mesh disc just below the surface, slightly off-center.
  3. Pump the plunger up and down with short, quick strokes for about 15 to 30 seconds. You should hear the sound change as air is incorporated.
  4. Once the foam reaches the volume you want, stop pumping and tap the jug gently on the counter to knock out large bubbles.
  5. Swirl the milk for a few seconds to blend the foam with the liquid underneath, then pour the milk into your coffee.

Tips for Adjusting the Texture

Keep the disc near the surface for more foam and lower it slightly for a smoother, denser texture. Pumping more slowly produces finer bubbles, while faster strokes give a lighter, airier top. Expect the foam to settle within a minute, so pour soon after you finish.

Common Mistakes to Avoid

  • Filling the jug past one-third. The milk expands, and you will end up with a mess and uneven foam.
  • Using milk that has been warmed first. Warm milk does not hold foam as well as cold milk.
  • Skipping the tap on the counter. Large bubbles look rough in a cappuccino.
  • Letting dried milk sit on the mesh. Rinse the disc right after use so residue does not affect later batches.
  • Pumping too hard and splashing. Use controlled strokes and keep the jug on a flat surface.
  • Barista-style oat or plant milk is worth buying if you use dairy alternatives, since these are formulated to foam more reliably than standard versions. View on Amazon
  • A stainless steel frothing pitcher with clear volume markings helps you keep milk to the right fill level and makes pouring easier. View on Amazon
  • A milk frothing thermometer is useful if you also steam or heat milk, so you can hit the target range without guessing. View on Amazon

For more on matching foam to drinks, see Latte vs Cappuccino vs Flat White: Milk and Foam Explained and How to Froth Oat, Almond and Other Plant Milks. If you are comparing handheld options, Best Handheld Milk Frothers covers other styles.

FAQ

Can the Bodum Schiuma froth cold milk?

Yes. Cold milk is the standard starting point, and it produces firm, lasting foam. You can also froth warm milk, though the foam will be less stable.

Which milk gives the best foam?

Whole dairy milk usually gives the thickest, most stable foam. Barista-labeled plant milks are the best non-dairy choice.

How do I clean the frother?

Rinse the mesh disc and plunger in warm water immediately after use, since dried milk is hard to remove. Check the manufacturer’s care instructions for any parts that should not go in the dishwasher.

Conclusion

With cold milk, a jug filled to one-third, and steady pumping, the Schiuma produces foam that suits most home coffee drinks. Adjust the depth of the disc and your stroke speed to change the texture. A quick rinse after each use keeps the mesh working well for the long run.

Claire Whitaker

About Claire Whitaker

Claire Whitaker is part of our editorial team and reviews and edits our coffee gear & accessories guides, checking product details against manufacturer specifications and owner feedback.